My Refrigerator Refuses to Run After Being Transported To Our New Home?

Technician repairing refrigerator

 

If you’ve done this and your refrigerator is still hot after a few days, you will likely need a replacement because yours is too damaged. It is tempting to constantly check how cold the refrigerator has cooled, but opening the door repeatedly or for long periods of time will release fresh air. This will of course make the refrigerator take longer to cool.

Turn off the refrigerator and unplug it a few hours before moving it to thaw the evaporator. After moving, keep the refrigerator upright for at least 24 hours before the plumber plugs in the water dispenser and ice maker. Always unplug the refrigerator from the electrical outlet and disconnect the water supply before troubleshooting.

If you have tried all of the above tips and the ice maker is still not working, plug your refrigerator back in and use Appliance Repair OKC Services to schedule to repair your refrigerator. To get your freezers, fridges and more ready for your move, our appliance repair technicians can help you, especially with repairing appliances. If these items are confirmed, call our office and we will troubleshoot your refrigerator and ice maker to find a solution.

Without proper preparation of the freezer, refrigerator, and other water-consuming appliances, water can become cluttered on the move. In addition, if you do not defrost your refrigerator or freezer, moisture from the melting ice can wet the working parts of the refrigerator or cause mold to form inside the unit.

If the freezer is very cold, unplug the refrigerator and open the freezer door to melt the frost. Check the compressor by unplugging the refrigerator for about 2 hours and then plugging it back in.

Tip If the compressor in your refrigerator wears out, it is likely to turn on more often or you will notice problems such as food spoilage. If you buy a new refrigerator, it will likely take less time to cool down than the old one. A good rule of thumb is to keep a lot of food in the refrigerator to keep it cool, but don’t pack it so tightly that air can’t easily circulate from shelf to shelf. Lack of space can cause the compressor to overheat and shut down the refrigerator.

Vacuum the coils under or behind the refrigerator to improve cooling. Keep the coils on the back and bottom of the refrigerator clean using compressed air and a non-corrosive cleaning fluid. If you find a lot of dust accumulated on the coils, plan to clean them once or twice a year to keep the refrigerator properly cooled. Make sure there is adequate airflow behind and around the refrigerator to provide better cooling, and keep the fans clean and free to operate.

Make sure you do this at least a few hours before moving the refrigerator. If you need to put the refrigerator back in place at any time, do it slowly and with someone else on the other side to help lower it. Use a board to drive the refrigerator into a moving truck or pickup truck. Attach the refrigerator to the truck using additional straps along the top and sides of the refrigerator.

If for some reason you need to move the refrigerator to its side, make sure you keep it upright twice as long as it was on one side before turning it back on. After reconnecting, wait for the manufacturer’s recommended amount of time before adding products, which ranges from 24 to 72 hours. If you’ve moved the refrigerator to one side – or if it was brought to your home on one side – it’s important not to turn it on right away, or you risk damaging the compressor. If your refrigerator has been lying on its side, it must be placed upright for the same amount of time (or 24 hours) before being put into service.

Oil from the compressor can seep into the cooling pipes at this point, preventing the refrigerator from cooling. After the refrigerator has been moved to one side, it must remain upright for the same amount of time as it has been on one side. The cooling system must be properly stabilized when the appliance is in a fully upright position before it can be used safely, especially if tilted or held on its side while driving.

Remember, refrigerators are heavy, so you may want to consider using professional film to move your appliances, especially when you have to go up and down stairs. If you are moving the refrigerator to a new home, keep it as vertical as possible.

Lubricant seeps from the compressor into the cooling pipes, and if you turn on the appliance too quickly while standing on its side, the compressor may be irreversibly damaged and the refrigerator will stop working. In any case, once you arrive at your destination, it is recommended that you leave the refrigerator upright and disconnected from the power source for at least two hours before restarting it so that oils, gases and coolants can drain back to the right place. If the compressor makes a lot of noise when it is turned on again, it may have been damaged in transit, or you may just have a defective compressor. At this point, it is probably best to contact customer service – Appliances Online can help you locate the manufacturer’s contact details. If you absolutely cannot avoid moving the refrigerator in a lying position, then you can try to minimize oil leakage by placing the refrigerator on its side with the compressor tube facing up, in other words, if the compressor lines are exiting to the right. side, place the refrigerator on the left.

In addition, the design of the refrigerator does not allow upside-down movement (especially when moving), because the installation equipment for all heavy components is designed to have only one way: to prevent the components from being crushed. For example, manufacturers says its compressor stand is designed to absorb compressor vibration when the refrigerator is in an upright position-moving it sideways will cause it to be unable to absorb lateral stress. How to rearrange the refrigerator largely depends on the width and width of the door. The refrigerator can be moved on its side, but this is not advisable.

You will need enough ice cubes to keep the food properly refrigerated during the move, and the time required to keep the refrigerator free after moving. If you have a refrigerator/freezer combination, the freezer may take longer to cool down because it needs to reach 0 degrees Fahrenheit to store food safely. In order to easily move the refrigerator out of the house without damaging the operating system or ice machine, you need to be very careful when preparing appliances and moving the refrigerator/freezer/freezer. Freezers use the same type of refrigeration system as refrigerators, and you need to be careful when moving them so as not to damage the internal coils or refrigerant.

For refrigerator repairs in Oklahoma City be sure and contact Appliance Repair OKC Services. They can be reached at 405-378-4566. You can also visit our website at https://www.okcappliance.com or alternatively our Google business page at https://cutt.ly/YEnc8qk. You refrigerator is a major appliance. If you have problems after moving your fridge call for service now!

 

The post My Refrigerator Refuses to Run After Being Transported To Our New Home? appeared first on Appliance Repair OKC Services | Best Appliance, Washing Machine Repair Company in Oklahoma.