My Washing Machine Won’t Start?

Mature Woman Looking At Male Technician Repairing Washing Machine

 

 

My Washing Machine Won’t Start?

If the washer does not begin, but only makes one sound, it is possible that the washer is draining something. One issue that you are going to need to address in your washing machine troubleshooting is that your washing machine simply does not start. If it is not an electrical issue, the washing machine not turning on may be having a problem with the motor. If you can hear the washer trying to turn on, but then fail, your motor has failed.

If everything else fails, then a bad part may be stopping your washer from starting. If you do not see any signs of damage, reconnect your washer to check the electrical supply to the circuit board(s). If the washer does not boot up after pulling the timer knob, check it for continuity using a multimeter. To check, just push forward on the timer and try restarting the washer again.

You will also want to check the timing knob and the lid switch, just in case any of these parts are the reason why your washer is not turning on. To make sure that the lid switch is at fault, disconnect power to the washer, and then pull a cord out from underneath.

If The lid/door switch is broken, it is never sent a close signal, and your washer will never believe that it is safe to begin. A broken lid/door switch cannot send the signal, so your washer still thinks it is unsafe to start washing. The washer knows that the door is open using a lid/door switch, which has a pressure tab which detects when the door is closed, and that you are safe to begin a washing cycle. Front-loading washers use the door switch, latch, and slammer, which you have to press in order for the washer to begin.

The starting switch can be tested and replaced in a rather straightforward procedure for top-loading washing machines, and is part of the computer in front-loading washers. For older top-loading washing machines, the start switch (and usually a defective timer) can be replaced by removing the rear plate from the top control panel. If a mechanical timer knob does not align correctly with the graphics on the control panel, you may try troubleshooting your washing machines problems by moving the timer forward slightly. If the lid switch works, but the washing machine still does not boot, see if the washing machine has a specific fuse within the control panel to deal with this.

If you have checked for all of the above issues and the washing machine still does not start, then do not panic, this may still be a repairable issue. If you had a hard washing day, running a few loads consecutively with no problems, but your machine will not start anymore, it may be that it is overheating. If you run a few loads, one after another, without issue, but suddenly find that your washing machine will refuse to start, it is possible that overheating is to blame. If the overheating happens only once or twice, that might not be an issue, but if your washing machines motor is constantly overheating, it is crucial that you figure out what is really causing this.

As a result, this may result in your washing machine stopping working suddenly, and such a sudden power loss could cause your washing machines control board to break. A bent circuit breaker may also cause sudden power loss in your washer. Wear can lead to your washing machines control knobs no longer engaging properly with the spool, so that you cannot adjust time or any other functions in the washing machine. Your washers lockout may be affected by several problems, such as a switch that is not working properly or is damaged.

If your knobs in your washing machine switch power or switch power are cracked or broken, then your washing machine might not turn the switch on. The number one reason why your washing machine stops working all of a sudden is because there is not any electricity. Motor If your washing machines motor gets too hot, your washing machine will turn off so that it can cool down before you can run it again. Simply let your machine cool down for a couple of hours before trying to start it again.

If you cannot get access to your washing machines outlet to reset your machine manually, then shut the circuit breaker. Check and reset the breaker if needed (or change a fuse), and then try starting your washing machine again. If your washer still does not start, disconnect or flip the circuit breaker off, then switch back on until the breaker firmly clicks in place, and plug the machine back into an outlet.

As always, you will want to disconnect the washer from the wall to avoid any injuries. While this might sound like a smart idea, check back in with your washer if it is still connected. The first thing you want to do is to make sure that you are not overloading your washing machine with loads that it cannot handle. Unfortunately, finding out that your washing machine is not going to start often happens when you are completely loaded up with dirty clothes.

Your washing machine will make a few sounds, but if you begin to notice that it is making weird sounds you have not heard before, that is a great sign that something is wrong. If the buzzing noises you are hearing while trying to use the washer are accompanied by a burning smell, your machine might be in serious trouble. If the washing machine is not spinning, that could be an indication of a problem requiring a repairman, but usually, a simple DIY repair can make the washing machine function again.

Remove the power supply to the washing machine before troubleshooting or trying a repair. If this is an issue caused by your appliance being too hot, simply allow the machine some time to cool, disconnect and let the machine sit for several hours, and then try to reconnect.

To schedule washing machine repairs in Oklahoma City contact Appliance Repair OKC Services by calling 405-378-4566 or you can visit our website at https://www.okcappliance.com. Also our Google business website can be found at https://cutt.ly/YEnc8qk. Call now!

 

The post My Washing Machine Won’t Start? appeared first on Appliance Repair OKC Services | Best Appliance, Washing Machine Repair Company in Oklahoma.