My Refrigerator Went Off And Now Won’t Start Again?
Once it is done, you can re-plug the fridge back into a wall outlet. You can disconnect the refrigerator, then check for the overloaded relays and overloaded power supply with the help of a multimeter. The overload relay is the protective device used on your fridges compressor circuit.
Once you are done replacing it, power the fridge back on, and see if the issue has been solved. If you actually replaced your fan or one part of the fan motor, then you need to turn the fridge back on and test if the problem is now solved.
If your fridge starts again after unplugging, it is very likely the compressor is defective and needs a professional to replace it. Test your compressor by disconnecting your refrigerator for approximately 2 hours, and plugging it back in.
Once it is done, you can re-plug the fridge back into a wall outlet. You can disconnect the refrigerator, then check for the overloaded relays and overloaded power supply with the help of a multimeter. The overload relay is the protective device used on your fridges compressor circuit.
The chiller is the temperature-control switch which supplies electricity to the compressor and fan circuits on the refrigerator. When the refrigerator fan is running, that means that both the defrost timer and cold control on the refrigerator are set to COOL. The purpose of a fan is to move heat away from condenser coils, and when a fan is malfunctioning, your fridge is not cooling down fast enough, and will continue running for longer than necessary.
If either one of your fans is failing, or if your compressor is off, the fridge is going to provide very little or no cooling. If your appliances set temperature is too low, you do not have a chance of getting the humidity out of the air while your appliance is cooling. When levels of adequate cooling agents get insufficient, your refrigerator might not function as it should.
If you adjust your refrigerators thermostat for more cold air, the fridges compressor will activate, forcing less air to flow through the cooling fan. If you do not correctly adjust the thermostat, your refrigerator shuts down, then turns back on as temperatures rise. If the refrigerator is turning off, and you can make it work by turning on and off the refrigerator using the thermostat knob, the thermostat might be the problem.
If your fridge does not start, and no fans are running, then you may have a faulty control. If your fridge does not get any cooling, it is the electrical controls that are nearly always causing the problem – it is not a demand for more refrigerant. Instead, a refrigerator might have dirty condenser coils, a door that does not close tight, or defective temperature controls. If the refrigerators compartment is freezing the contents, even with the cooling control set at the lowest setting, it is very likely the fault is in your fridges temperature sensing unit, or in its refrigeration controls.
Even if your refrigerator is otherwise working properly, the cool air from within your cooler can escape if a door seal–also called the door gasket–is not working properly. Door gaskets for fridges and freezers are another possible cause for the refrigerator to not stop working. After you have disconnected your refrigerator, use the control panel located within the fridge to shut down both the fridge and freezer. Unplug your refrigerator before you clean out the coils, fans, and compressor.
Remove the rear access panel from your fridge, then find the fan — it will be near the compressor. Plug in the fridge, and ensure that the condenser fan is running while the compressor is running. Normally, when your thermostat calls for extra cooling, your fridges condenser fan and compressor, located near the floor in the back of most refrigerators, will turn on.
When you turn the refrigerator on, the thermostat sends a signal to the starter capacitor, which activates the compressor and starts the fridges cooling cycle. A faulty thermostat cannot transmit start signals to the start capacitor, and the refrigerator does not start.
When the thermostat for malfunctioning frost shutdown becomes faulty, it does not work properly, your fridge keeps running. The defrost timer might fail to trigger a Whirlpool fridge to restart after completing the defrost cycle.
One of the most common causes for the fridge running continuously is the faulty defrost timer. Several factors can cause a fridge to temporarily run continuously. If your circuit breaker is tripped, or your fuse is blown, it is preventing power from reaching your fridge.
If you can hear the compressor running, but the refrigerator is not cooling, then it is most likely that a freeze-clogged evaporator coil is to blame, or that a plugged-in or broken evaporator fan is the issue. If the compressor seems to be running, or is making some sort of buzzing or acoustic sound, but your refrigerator is not cooling at all, it is time to call in the service professionals. A simple way to check your compressor to see if it is overheating and needs replacing is to disconnect your refrigerator for two hours and let the compressor have a chance to cool.
If you spin your refrigerator upside down and power it up, your refrigerator might still work a little, but you are at high risk of actually damaging the compressor in your refrigerator and breaking your appliance. By leaving it sitting there for several hours, you can safely power it back on again, with no fear of damaging it. You might want to have this repaired before your whole fridge stops working entirely. After the refrigerators compressor has been running for eight or 10 hours in a certain time frame, a defrost timer kicks off the defrost cycle, shutting the compressor down, in effect giving it a moment to defrost.
To schedule refrigerator repairs in Oklahoma City contact Appliance Repair OKC Services by calling 405-378-4566 or visit our website at https://www.okcappliance.com to also our Google business page at https://cutt.ly/YEnc8qk. Call now!
The post My Refrigerator Went Off And Now Won’t Start Again? appeared first on Appliance Repair OKC Services | Best Appliance, Washing Machine Repair Company in Oklahoma.
No comments:
Post a Comment